Karamba3D 2.2.0

Search…

English 英文

1: Introduction

2: Getting Started

3: In Depth Component Reference

Troubleshooting

Appendix

A.2.1: Basic Properties of Materials

Material Stiffness

The stiffness i.e. resistance of a material against deformation is characterized by its Young’s Modulus or modulus of elasticity **“E”**. The higher its value the stiffer the material.

Table A.2.1.1: Young's Modulus of materials (E-values) for some popular building materials

Type of material

$E [kN/cm^2]$

steel

21000

aluminum

7000

reinforced concrete

3000

glass fiber

7000

wood (spruce)

1000

For composite materials – like in the case of rods made from glass fiber and epoxy – it is necessary to defer a mean value for **“E”** using material tests. Karamba3D expects the input for **“E”** to be in kilo Newton per square centimeter (

$kN/cm^2$

).If one stretches a piece of material it not only gets longer but also thinner: it contracts laterally. In case of steel for example lateral strain amounts to 30% of the longitudinal strain. In case of beams with a large ratio of cross section height to span this effect influences the displacement response.

In common beam structures however this effect is of minor importance. The shear modulus **“G”** describes material behavior in this respect.

Specific Weight

The value of **“gamma”** is expected to be in kilo Newton per cubic meter (

$kN/cm^3$

). This is a force per unit of volume. Due to Earths gravitational acceleration ($a=g=9.81 kg m/s^2$

) and according to Newtons law ($f=m \cdot a$

) a mass m of one kilogram acts downwards with a force of $f=9.81N$

. For calculating deflections of structures the assumption of $f=10N$

is accurate enough. If you want a more precise value change the entry “gravity” in the “karamba.ini”-file. In case of Imperial units the exact value for “gravity” is automatically set – otherwise the conversion from lbm to lbf does not work properly.Table A.2.1.1 gives specific weights of a number of typical building materials. The weight of materials only takes effect if gravity is added to a load case (see section 3.2.1).

Theoretical Background of Stiffness, Stress and Strain

Strain is the quotient between the increase of length of a piece of material when loaded and its initial length. Usually one uses the Greek letter

$ε$

for strains. Stress is force per unit of area. From the stress in a beam cross-section one can calculate the normal force that it withstands by adding up (integrating) the product of area and stress in each point of the cross-section. Stress is normally symbolized by the Greek letter $σ$

. Linear elastic materials show a linear dependence between stress and strain. The relation is called Hooke’s Law and looks like this:

$σ = E \cdot ε$

Hooke’s law expresses the fact that the more you deform something the more force you have to apply.

Last modified 1yr ago